Extron-electronic RSB 126 User Manual download pdf (Page 23)

SW USB Series • SIS Conguration and Control

SIS Conﬁguration and Control, cont’d

4-4

SW USB Series • SIS Conguration and Control

4-5

Command

ASCII Command

(host to unit)

Response

(unit to host)

Additional description

Firmware version, part number, and information requests

Request information I

Chn

• InACT

• OutACT

• Emul

]

Show the selected input and output.

= Activity of all inputs and outputs

For SW USB Plus only:

= Mouse emulation switch position

= Keyboard emulation switch position

For

and

: 0 = off (down); 1 = on (up).

Request part number N

60-95n-nn

]

Show the SW USB part number.

SW2 = 60-952-01, SW4 = 60-953-01,

SW4 USB Plus = 60-954-01.

Query rmware version Q

n.nn

]

Show rmware version, expressed to the second

decimal place.

Example:

1.01

]

Query version and build *Q

n.nn.nnnn

]

Show rmware version and build number.

Reset

ZXXX

}

Zpx

]

Reset the switcher to factory default values.

Upload ﬁrmware

Upload rmware

Upload

}

...go

Upl

]

Upl appears after the upload is complete.

Command/response table for SIS commands

Command

ASCII Command

(host to unit)

Response

(unit to host)

Additional description

Input selection

Select input

! Chn

]

Select input

for both the SW USB and the

attached A/V switcher (if any).

Select SW USB input only

^ USB

]

Select input

on the SW USB only (not passed

through).

Conﬁgure RS-232 pass-through

Send input selection commands

via contact closure, front panel,

or the RS-232 interface

0LOOP

}

Loop0

]

Input selection commands (only) issued via the

front panel, contact closure, or the RS-232 interface

are sent to an attached A/V switcher via the RS-232

Pass Thru port.

Send SIS commands via

computer RS-232 interface

1LOOP

}

Loop1

]

All available commands issued from an RS-232

interface can be performed by the SW USB and

passed through to a connected A/V switcher.

View loop out setting

Loop

}

Loop

]

View pass-through setting

. For

0 = Input selection commands can be issued

through contact closure, the front panel, or

RS-232. (Loop 0 mode)

1 = All supported SIS commands can be issued

through the RS-232 interface. (Loop 1 mode)

Front panel lockout

Enable executive mode 1X

]

Lock the front panel.

Disable executive mode 0X

]

Unlock the front panel.

Lockout status X

]

Show executive mode on/off status.

Command/response table for SIS commands (continued)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Extron-electronic RSB 126 User Manual Page 23

Comments to this Manuals

Related products and manuals for Computer Accessories Extron-electronic RSB 126